News
NEWS CENTER
The correct use and installation method of reducer
Release time:
2018-12-07
The installation and use of the reducer is directly related to the operation effect of the reducer, and it must comply with technical specifications and standards. The trial operation time of the reducer should not be less than two hours. The standard for normal operation is stable operation, no vibration, no noise, no leakage, and no impact. If abnormal conditions occur, they should be eliminated in time.
The installation and use of the reducer is directly related to the operation effect of the reducer, and it must comply with technical specifications and standards. The trial operation time of the reducer should not be less than two hours. The standard for normal operation is stable operation, no vibration, no noise, no leakage, and no impact. If abnormal conditions occur, they should be eliminated in time.
The transmission coupling of the reducer should be equipped with protective devices when necessary, such as protrusions on the coupling or the use of gears, sprockets, etc. If the output shaft bears a large radial load, it should also be reinforced. Before the reducer is operated, it is necessary to prepare for operation, remove the vent plug of the oil pool and replace it with a vent plug, open the oil level plug screw to check the height of the oil line, add lubricating oil beyond the oil level plug screw until the hole overflows, and then screw on the oil level plug and confirm that it is correct, then the trial operation can be started.
There are many optional types of couplings used in the reducer, but it is good not to use rigid fixed couplings. The installation of such couplings is more difficult. Once installed improperly, the load will increase, which will easily cause the bearing. Damage, and even cause the fracture of the output shaft. When installing the reducer, pay special attention to the alignment of the central axis of the transmission, and the error in the alignment cannot exceed the amount of compensation used by the coupling used by the reducer. After the reducer is aligned according to the requirements, a more ideal transmission effect and a longer service life can be obtained.
The fixed reducer is very important, to ensure smooth and firm, in general, we should install the reducer on a horizontal foundation or base, while the oil drain tank should be able to exclude, and the cooling air circulation is smooth. Worm gear reducer fixed is not good, the foundation is not reliable, there will be caused, vibration and other phenomena, will also make the bearing and gear by unnecessary damage. Reducer is a common power transmission mechanism, which is used in various mechanical transmission systems.
Key words:
Related News
Several Methods of Reducing Gear Noise
2024-01-17
Noise generation mechanism of reduction gear
2021-04-20
Contact Information
Mobile:86-13813562229
Telephone:86-13813562229
E-mail:Honest118SR@163.com
Address: 65-21 Xinggang Road, Zhonglou Economic Development Zone, Changzhou City, Jiangsu Province
Focus on us
Copyright 2024 Changzhou Xinjinyu Transmission Technology Co., Ltd. All Rights Reserved